Recording Process

IMPORTANT – Tell the presenter IF THEY MAKE A MISTAKE and want to RE-RECORD: The process is the same for every time this might happen: 

 
Tell them to PAUSE FOR 5 seconds, then REDO the CURRENT SLIDE entirely NOT THE ENTIRE PRESENTATION.  (We can trim out the rerecorded areas in Panopto in post-production.) 

 

Press the ON button under RECORD on the right upper area of the switcher 

 

Every 10 seconds or so, OR at a natural break when the presenter pauses, and/or changes the slides, PRESS THE AUTO button, which will switch the combined recorded feeds from one input to the other.  

 
(Pressing AUTO is a toggle which will switch between the two input feeds each time pressed, and will transition smoothly, for the amount of time shown above the AUTO button on the switcher.) 

 

In addition to the combined mp4 being recorded, the ATEM switcher is also recording the individual HDMI input feeds. (more on using these in post-production later) 

 

When presenter is finished PRESS THE Stop button under RECORD on the switcher 

REVIEW THE RECORDING before presenter leaves (see how below)